Test Equipment and Fault Diagnostic

Objective: To provide delegates with the necessary knowledge skills and safe working practices to enable them to safely undertake a range of electrical tasks in an industrial environment.

Course duration: 3 days

Pre-course requirements:

Delegates can be in any of our three levels of achievement to attend this programme, but need to have the core 5 days course knowledge from the Electrical Safety and Fundamentals to progress to the next level of moving on to be an instructed person and a skilled person going forward

PROGRAMME OUTLINE

Course Content:-

• Duty Holders
• Electrical Safety – the requirement for safe isolation procedure
• Electrical Safety – introduction to safety checks on motor circuits
• Types and use of test equipment
• Testing and BS 7671 (GN3 – GS38)

This is an introduction and a pre-requisite course to help delegates move forward with learning and knowledge building in the Electrical Engineering areas, and there will be home study required along with practical exercises.

Delegates would benefit from purchasing the following book prior to the course starting which can be purchased on Amazon:-

Students Guide to the IET Wiring Regulations (Electrical Regulations)